Android (MTRoA) switching behavior with Microsoft Integration

When using Microsoft Azure integration with a Android Microsoft Teams Room devices, Ochno O-PC-3 and Ochno LED-sockets below switching behavior is to be expected.

Note. Depending on Android system and connection between video bar and touch controller, the controller in BYOD mode can show “no connection”.
When disconnecting your laptop, the controller will go back to MTR mode after a few seconds. This varies from producer and systems.

→ No MTR meeting active.
Connect USB-C to your laptop - white light on Ochno LED socket (charging only)
Press button on Ochno LED socket. Light will change to blue (content ingest, only video).
Press second time and light will change to orange (BYOD, video and USB).
Press third time and light will change to white (charging only).

→ Ongoing MTR meeting.
Connect USB-C to your laptop - white light on Ochno LED socket (charging only)
Press button on Ochno LED socket. Light will change to blue (content ingest, only video).
Press second time and light will change to white (charging only)
BYOD mode will not be able during a active MTR meeting.

→ Ongoing MTR meeting where you exit (disconnect) the MTR meeting via MTR controller.
In this scenario the computer is already connected and sharing (blue light). When you disconnect the MTR meeting, you will continue to share your screen (blue light on LED socket).
Press button on Ochno LED socket. Light will change to orange (BYOD, video and camera).
Press second time and light will change to white (charging only)

Recommended settings in Ochno O-PC-3 for Android MTR systems with LED sockets.

Open	Under UC System Settings: Select “Android-based UC System”. Select “buttons cycle through modes” Select all ports so that when selected they start in UC-mode = Content ingest, video only.
Open	Under Switch settings: Select “None” under Default port Since we are using Ochno LED sockets for switching - none is selected for automatic switching. Select both “Active device” and “Last device” when disconnecting. Select “None” under Turning off active port with button switches to.