...
Which settings you can configure varies depending on which product you have and the firmware version.
Settings in detail
Configure MTR
Start by selecting which kind of hardware you are using. You have two options:
...
Active device – When you disconnect a device from the currently active port the last active MTR mode is forgotten.
Last device – When the last device disconnects the last active MTR mode is forgotten.
Active device and Last device – The combination of the above choices.
...
Examples
You are connecting an MTR using port 1 and use Ochno LED sockets with the other ports. You want it to be possible to use both MTR mode and BYOD mode on the other ports.
...
For this scenario it is required to set both automatic switching and MTR settings. Look into these settings:
Enable automatic switching on disconnect. See the switching support page for more information. If you are using a PC-based MTR, make sure to disabled auto-switching for that port.
Use the ”Holding button changes mode” profile and change the ”MTR mode resets automatically” to the corresponding option that you use for the automatic switching.
Terminology
Hub: The Ochno Power Conference.
Ports: The hub’s USB-C ports.
Active port: The port that is currently connected to the hub’s video and USB peripherals (passthrough). Only one port can be active at a time.
Button: Any kind of Ochno button, such as the Ochno LED Socket.
Device: Your computer, phone, tablet, or anything else that connects using the USB-C port.